The laser range of cell phone jammer is commissioned

The laser range of cell phone jammer is commissioned.
Three on the left click on the coordinate system to move the plane from the position; rotate, select the action you can move the plane relative angular position. Delete the redundant point data: the editor in the left column, select the need to deal with point cloud data, right-click to select the filter the data, 2.5D the raster is selected, will appear the following dialog box: select the plane you just created in the reference plane select the distance of the point needs to be filtered in width, in the mode drop-down box, select the type of filter: True the Minimum (reservations to the plane of the lowest point, the lowest point of all of the above points). Tick in front of colleagues to remove redundant points triangulation. It is the preheating time of cell phone jammer .
In some cases, the need for manual intervention. Click on the toolbar, the following diagram dialog box will appear: select the plane in the plane through the bandwidth setting range up and down the value of the offset set the location of the deleted point, the increment is set to remove the belt interval. Press the + / - number buttons to move the deleted band. The establishment of the triangular network model: select all of the point cloud data, right-click to select the triangulation-plane triangulation, a dialog box of the following figure: change dialog box can be adjusted to establish the angle of the triangular network size and the side length. Establishment of contour lines: the establishment of the triangular network model based on click of a button, pop-up dialog box. If the ambient temperature is too low, the preheating time of phone jammer might be longer.
Should be noted that: delete the relevant point in the TPL list, but also delete the data of the corresponding photo in the left side of the edit box. Scans in, right-click the icon of scanned data, select the image The acquisition in the box; will appear for the first time you select the camera model prompts, click OK, and the following dialog box, select the camera model: take the same steps the instrument will automatically align to scan the target position to take pictures. Open the photo, select the button to show the TPL the POCS is selected in the drop-down box, the photo will appear in the corresponding scan point coordinates: the center of the reflective film is selected, hold down the shift click in the photo view, after the right-click and select add point to the TPL In the pop-up dialog box. For example, the red laser beam light is emitted by the red phone jammer .